User: Guest |  Site Map |  My BSAC Profile

BPN845: 3D Printed Finger-Powered Microfluidic Pump and Mixer

Project ID BPN845
Start Date Wed 2016-Aug-24 00:11:30
Last Updated Wed 2016-Aug-24 14:51:18
Abstract Low-powered microfluidic systems have been demonstrated in a variety of point-of-care biomedical diagnostic applications; however, the potential for the widespread commercial applicability of this technology, the requirement for being portable, disposable and inexpensive, is greatly hindered by the nearly-ubiquitous need for bulky and expensive externally- powered pressure sources needed to pump fluids through such devices. Furthermore, as advanced additive manufacturing techniques such as micro/nano-scale 3D printing are becoming more widely used in BioMEMS manufacturing, conventional soft- lithography fabrication approaches are becoming comparatively more costly, time consuming and labor intensive. To overcome these critical limitations of conventional microfluidics, for this project we propose a low-cost microfluidic one-way pumping and mixing system powered solely by the operatorís finger fabricated via micro-scale 3D printing. The three-dimensional geometric complexity permitted only by additive manufacturing processes allows for the construction of fully-integrated three- dimensional micro-scale fluidic control and actuation elements (i.e. fluidic diodes and thin membrane-enclosed interconnected balloon cavities and capacitor- like fluidic actuation source). We demonstrate a 3D printed one-way microfluidic pump, allowing the user to pump fluid at upwards of 150 micro-Liters/minute, with flow rate correlating to the pumping frequency. Furthermore, we will demonstrate the application of two integrated one-way pumps as a 3D printed microfluidic mixer capable of rapid pulsatile mixing of two fluids, powered by a singular shared finger-powered pump. Our finger- powered 3D printed microfluidic devices have established an alternative to conventional externally-powered microfluidics, and upon further development, such designs could prove critical tools in resolving the foremost commercial limitations of conventional microfluidic point-of-care diagnostic devices.
Status New
Funding Source BSAC Member Fees
IAB Research Area Microfluidics
Researcher(s) Eric C. Sweet, Ilbey Karakurt, Rudra R. Mehta
Advisor(s) Liwei Lin
Detailed Information
Secure Access

Private Abstract
Research Report
Summary Slide PDF | VIDEO
Active Feedback (or Request for Response)


  • Copyright Notification: All papers downloaded from this site are © University of California or the publisher, all rights reserved. Contact the BSAC Webmaster for permission related to copyrighted materials.
  • Links on these pages to commercial sites do not represent endorsements by UC or its affiliates.
  • Privacy Policy
  • Contact Us
  User logged in as: Guest
  User Idle since: June 20, 2018, 11:43 pm